The wire cutting fluid manufacturer tells you that the wire cutting rust remover uses heavy oil cleaning agent

1. Workpiece cleaning and rust removal

1.1 The amount of wire cutting rust remover depends on the degree of corrosion of the workpiece, and it can be diluted without dilution or 1:1 to 1:2. The liquid medicine can be put into a spray can and sprayed on the surface of the workpiece, or put into an open container and dipped with a brush. You can also immerse the whole work piece in the liquid medicine and wait a while for the liquid medicine to take effect. Then wipe the surface of the workpiece with a brush or soft cloth, then rinse it with running water as soon as possible, and dry the workpiece with an air gun, and finally spray anti-rust oil;

1.2 It is recommended to wear rubber gloves when washing, especially when there are wounds on the skin on the hands

1.3 Please do not mix the wire cutting rust remover into the water circulation system of the machine tool, otherwise it will significantly increase the conductivity of the working fluid, which will affect the normal processing and increase the loss of resin and waste man-hours.

2. Processing tank cleaning:

2.1 Used to clean the discharge residue and dirt stuck in the processing tank: first put the chemical liquid into the watering can and spray it on the water tank and the workbench, and then scrub with a brush. Finally, it must be fully rinsed with clean water and ensure that the sewage is not discharged Processing fluid circulation system.

3. Other cleaning purposes:

3.1 Wire cutting rust remover is a multi-purpose cleaner. It can clean ceramic tiles and perform high-pressure cleaning. It can also remove scale, urine, rust, grease, sweat and so on. Just add 1 to 2 small cups of wire cutting rust remover to 10 liters of water.